Work Process

1. Site Survey & Planning

• Assess the location (visibility, distance, angle, height).

• Check power supply availability and load capacity.

• Confirm internet/network connectivity (LAN, 4G, WiFi).

• Inspect the structure to ensure it can support the LED screen’s weight & wind load.

• Take measurements for screen size and mounting design.

2. Structural Preparation

• Design a steel frame or wall mount (engineer-approved).

• Ensure structure is stable, rust-proof, and weather-resistant.

• Mark the positions for mounting brackets and cable entries.

3. Power & Data Cabling

• Install AC power lines with circuit breakers and surge protection.

• Lay data cables (CAT6 / Fiber) for signal transmission.

• Ensure proper grounding/earthing to protect against lightning and power surges.

4. Cabinet Installation

• Hoist and fix LED display cabinets one by one, starting from the bottom row.

• Align cabinets precisely using levels & alignment tools.

• Secure them tightly to withstand wind & vibration.

5. Module & Panel Assembly

• Install LED modules into each cabinet.

• Connect power cables (from PSU to modules).

• Connect data cables (from receiving card to modules).

• Ensure module flatness & uniformity.

6. Control System Setup

• Install receiving cards inside the LED cabinets.

• Connect them to the sending card or video processor in the control room.

• Configure screen layout using LED control software.

7. Testing & Calibration

• Power on and check each cabinet/module.

• Perform brightness & color calibration for uniform display.

• Run test patterns to verify pixel mapping & resolution.

• Check signal redundancy and backup power (if applicable).

8. Waterproofing & Sealing

• Seal cabinet gaps with rubber gaskets / waterproof tape.

• Ensure all cable entries are weatherproof.

• Apply anti-rust coating on exposed steel structures.

9. Final Adjustments

• Set optimal brightness levels for outdoor conditions.

• Adjust viewing angle & content scaling.

• Schedule automatic power on/off if supported.

10. Handover & Maintenance Training

• Provide client training for basic operation & content upload.

• Share maintenance guidelines (cleaning, fan checks, spare parts).

• Schedule regular inspections (monthly or quarterly).